Seat Inca 19 Sdi Service Manual
View and download the Seat Inca 2020 Owner’s Manual online.n Page 130 TIPS AND MAINTENANCE IN0-041 1.n9 SDI Diesel Engine Page 1 – Engine Oil Dipstick. Pull it up on most vehicles. Raise the lubricant pressure to at least 3.8 bar. I don’t know if this can affect, but make sure that the lube oil pressure is always within the normal range. If it drops, refer to the maintenance manual. 2.n10 Power systems – Be mindful of fuel consumption. Install a fuel filter that works as recommended by your service station. 3.n11 Engine systems – Check that the engine temperature sensor is working properly. Make sure the air filter has a mesh. If you are not receiving more detailed service information, call your service station for advice on replacing the air filter. 4.n12 Fuel injection devices – Check the operation of the on-board computer, which gives information about the amount of fuel in the tank, the value of the battery charge level, and the presence of a cold engine. If you do not use additional equipment for diagnosing your car, you should check whether the fuel parameters presented on the vehicle diagnostic stands correspond to the norm for your car. Invite a service engineer for a test drive, who will check the operation of the system and give recommendations on your car. 5.n13 Engines – Open the fuel tank cap to view the fuel level. Check if it is correct. If the fuel level is not correct, add fuel.Make sure that the fuel tank must be filled to the maximum level before the end of the entire time specified in the vehicle manual. 5n14 Piping – Make sure that all the pipes that go to the engine are at the same level. Make sure there are no leaks. Check systems that may be affecting the operation of the fuel pump or fuel filter, such as electronics or fuel pressure sensors. If the voltage is out of specification, contact a service station to correct the problem. 6.n15 Engines and components – Check that the drive belt is properly tensioned. After making sure that the engine power is correct (see appendix 8), you should check the system settings. If the optional equipment for vehicle diagnostics is not installed, you should check the system parameters using the vehicle manual.